15065 Autoloader ALE: Trailing edge clamp actuator bar cylinder error, both sensors activated Platesetter_3244 Trendsetter_400/800 Reports this error if both extended and retracted tec sensors indicate true after a tec backbone is lowered and a time of te_delay has expired. Only reported if te sensors enabled. Check that TEC magnets are lined up, this error will occur if the tec backbone is unable to go all the way down when it tries to retrieve the tec magnetic clamps. Otherwise call Creo service sensor or wire failure or TEC Lock failing to unlock or magnets or other obstruction preventing the TEC backbone from going all the way down. ../nvs/al_cal_nte.xmlNVS: al nte NVS: aldly te cal ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:32:50 2008 PST